Capacitive Touch Sensor - MPR121
Revision as of 11:38, 17 November 2010 by Robotix (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

From bildr

Jump to: navigation, search


MPR121.jpg
  • Manufacturer: Freescale
  • Voltage: 3.3v
  • Communication: I2C

This is a breakout board for Freescale's MPR121QR2. The MPR121 is a capacitive touch sensor controller driven by an I2C interface. The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode. The MPR121 also features eight LED driving pins. When these pins are not configured as electrodes, they may be used to drive LEDs.

There a four jumpers on the bottom of the board, all of which are set (closed) by default. An address jumper ties the ADD pin to ground, meaning the default I2C address of the chip will be 0x5A. If you need to change the address of the chip (by shorting ADD to a different pin), make sure you open the jumper first. Jumpers also connect SDA, SCL and the interrupt pin to 10k pull-up resistors. If you don't require the pull-up resistors you can open the jumpers by cutting the trace connecting them.

There is no regulation on the board, so the voltage supplied should be between 2.5 and 3.6VDC. The VREG pin is connected through a 0.1uF capacitor to ground, which means, unless you modify the board, you can't operate the MPR121 in low-supply voltage mode (1.71-2.75VDC).


Availability


This page is a Component on bildr. Components are pages about specific parts, and include connection details and code when available.

NOTE: All information contained within this article is pure opinion. Although this article is intended to help people, it may contain faulty or misleading information. This article is not to be considered professional opinion or advice, and is in no way a replacement for reading all safety/instructional documentation. Always remember to protect yourself when handling/using hazardous materials, as well as test new techniques before using them on projects/work intended to be handed in or used.

bildr and its contributers take NO responsibility for the information contained within.