Sensing Temperature (MLX90614 Arduino)

From bildr

Jump to: navigation, search

This Module is part of the grouping: Sensing Temperature


MLX90614 hookup.png

The MLX90614 is an Infrared thermometer, that by reading the infrared light coming off an object, can sense temperature between -95 and 720ºf (-70 to 382.2°C) with 17bit resolution.

This is an I2C , but unlike most I2C sensors, the MLX90614 can’t use the wire library to communicate with it, so we will be using another library, also, unlike what we typically deal with, the MLX90614 is not on a breakout board, so it requires some pull-up resistors on both the data and clock lines (Typically, these are included on the board, we just don’t notice them.)

As for hooking this up, on your Arduino (everything but the mega) SDA is on analog input pin 4, and SCL is on analog pin 5. On an Arduino mega, SDA is digital 20, and SCL is digital 21. Look at the picture to see how it should be connected, but a 4.7KΩ resistor needs to be connected from SDA to 3.3V, and another one from SCL to 3.3V. I also have a .1uf capacitor between power and ground as stated in the data sheet, but I have seen others not use it, and I have tested it without and it still worked.

Code

All this code does is output the temperature in both Celsius and Fahrenheit via serial. So open your serial monitor!

To make this code work, before you load the code, or even open the Arduino program, we need to place the “I2Cmaster” in your Arduino Library. Once the I2CMaster folder is in there, you can just go ahead and open MLX90614.pde in your Arduino software, and upload it.







This page is a Module on bildr. Modules are how-to pages on the creation of objects designed to be expanded upon.

NOTE: All information contained within this article is pure opinion. Although this article is intended to help people, it may contain faulty or misleading information. This article is not to be considered professional opinion or advice, and is in no way a replacement for reading all safety/instructional documentation. Always remember to protect yourself when handling/using hazardous materials, as well as test new techniques before using them on projects/work intended to be handed in or used.

bildr and its contributers take NO responsibility for the information contained within.